So what does this mean? That trying to idle your system will only save on average only 5% of your total power draw. The total wattage at this high percentage was still only 3W out of 18W total draw. That 15% only happened when the system was doing a hard drive stress test. This ranged from 3% to 15% of total power depending on what was going on. The hard drive is a minor part of total power consumption. This is working with an old Pentium M, but it backups up the ratios of power draw. research paper hosted at PSU - This PDF document has a component by component breakdown of power consumption. The cart is still good to understand the general power consumption. Knowing what we know about hard drive, that is a very generous number that probably takes an average of power usage over multiple idle events. That math puts hard drive consumption at 1.5W at 30W load and 4.5W at a 90W load. Written in 2009, it shows that a hard drive takes up about 5% of the total load of a system. MSDN Blog entry on power consumption - This page shows the power usage breakdown by component. I did some digging and found two interesting sources: Capture the amount of power used in each scenario over the course of at least an hour. Use the Kill-A-Watt like a power strip and run your laptop off of AC power. All you need is a power monitor like a Kill-A-Watt. This reduced the power load but doesn't sacrifice performance.īut you don't have to take my word for it, you can test this yourself. The better way to lower your power consumption is to switch a spinning disk (6-10 Watts) to an SSD (2 Watts). If anything accesses the hard drive, the power saving is lost since the drive has to spin up to fetch the data. That of course assumes that the hard drive remains idle while the program runs. The performance hit you are going to take by putting your programs on the SD card is not really worth the power savings of 2-4 watts. SD cards use about 1 watt at max load and are much slower than a normal hard drive. When reading data, an additional 3-5 watts are used. Simply having a hard drive plugged in can pull anywhere from 6-10 watts. A majority of power is used by an SD card reader is used to power the SD card itself. Short answer: Programs should go on Hard Drives not SD cards even though the SD card pulls significantly less power.
0 Comments
Leave a Reply. |